- Question Title: Fault emergency stop
- Asked by: Guest
- Asked On:
- Answers: 1
why the sudden "emergency stop" (emergency button is not depressed) when the GA22 screw compressor was working normally (load-unload) with temperatures of 93-98 ° C, pressure 6,3-7,1bar and ambient temp. 30 ° C
Answers & Replies
Log in or create an account to make a comment...
Hello Henda,
What is the exact message that get's displayed?
Does this unit has the Elektronikon 1 or Elektronikon Mark 3 controller (with the F1/F2/F3 keys below the display)?
This compressor has 4 safety stops:
If the compressor 'thinks' the emergency stop is pressed, while it wasn't, then probably there is a loose contact.
Carefully wiggle all wires that go to the emergency stop. Do the same on the controller
On the Elektronikon 1 controller it connects to connector 2X9 - pin 1. On the Elektronikon Mark 3 controller is connects to connector 2X9 - pin 3.
Good luck and let me know how it goes.
Cas